Searching...
Filters
SmallMediumLarge
Home Print Show Topic URL Previous Next
IT Management Suite
Client Management Suite
Server Management Suite
Deployment Solution
Asset Management Suite
ServiceDesk

Preparing unknown computers to boot with LinuxPE

Deployment Solution

After an unknown computer is added to a network, Deployment Solution boots the computer in the preboot environment using a Linux PXE image. You must configure the unknown computer to boot in the preboot environment before you install the Linux operating system (OS) on the computer. The computer boots in the preboot environment with a PXE image. For Linux, a PXE image is known as LinuxPE, which is configurable in Deployment Solution before you boot the unknown computer. The LinuxPE image contains the preboot files, the ULM Agent, and the Deployment Solution Plug-in that are installed on the client computer after the computer boots in the preboot environment. These agents are required for the execution of deployment tasks on the client computer.

This following process addresses how you must configure the settings to boot an unknown computer in the LinuxPE environment. After the computer boots in the preboot environment, the communication with Notification Server is established and the computer is registered as a managed computer.

You must perform the following steps to boot an unknown computer with the LinuxPE image:

Table: Booting an unknown computer with LinuxPE image

Step

Action

Description

Step 1

Launch the console

Launch the Symantec Management Console.

You can launch the console either from the Start menu of the Notification Server computer or from any computer of the network. To access the console from a different computer, you must type the following:

http://<IP address of NS>/altiris/console

Step 2

Install Network Boot Service on a site server

You must install the Network Boot Service (NBS) on a site server and also enable the policy before you configure the unknown client computer to boot in the preboot environment

See Installing Network Boot Service on site server

Step 3

Create a LinuxPE image

You must create a LinuxPE image through the Create Preboot Configurations dialog box of the console.

See Creating preboot configuration for Linux

Step 4

Configure NBS settings for unknown computers

You must configure the NBS settings for the unknown client computer from the console.

See Configuring Network Boot Service for unknown computers

For the unknown computer, you configure the NBS General Settings that lets you select the image to boot the client computer with and also configure the boot menu. Besides, you can also configure the NBS Global Setting that lets you filter computers based on MAC address to which the NBS site server must or must not respond.

See About NBS General Settings

See About filtering computers through NBS Global Settings

Step 5

Add the unknown computer to the network and wait for the client computer to boot to preboot environment

If you have added predefined computer entries through the console with no hardware identifier values, then the Linux unknown client computers boot in the preboot environment using the PXE image that was configured for predefined computers. You configure the PXE image for a predefined computer through the NBS General Settings dialog box.

After the computer boots to the preboot environment, Deployment Solution provides an option to boot the unknown computer as a predefined computer.